About

Sunil Darji is a highly skilled SoC System Validation Engineer with over 8 years of experience in post-silicon validation engineering, system design engineering, and embedded hardware-software development. He is currently employed at Intel as a System Validation Engineer. Sunil has extensive experience in bench characterization for Soc/IP validation for DSI-DPHY at different data rates, as well as debug and characterization of analog and high-speed modules. He also has experience in bench characterization of Buck, Boost, Buck-Boost Converter across PVT. Sunil has worked on the ORCAD tool for Schematic & Layout development for the Auto radar board project and has hands-on experience handling measurement equipment such as oscilloscopes, power supplies, AWG, source meter, VNA, DMM, and TCU. Sunil has strong knowledge of DDR interface and integration, characterization, and DDH PHY protocol. He has experience in firmware development and testing on COOCOX COIDE and CCS. He is also proficient in source code generation for STM microcontroller and has experience in lab equipment automation using LabVIEW and Python. Sunil has knowledge in dealing with high-speed embedded design, EMI/EMC analysis, overshoot and undershoot verification, signal and power integrity, clock and jitter measurement. He has excellent analytical and quantitative skills, the ability to integrate information from a wide variety of sources, and the ability to change and adapt to new situations. Sunil has previously worked at Mirafra as an HSIO - Post silicon validation engineer @Qualcomm, where he was responsible for electrical validation/ characterization of DSI-DPHY parameters, debugging issues, recording results, reviewing test results, and producing acceptance test reports. He has also worked at Petrotec-Retail Petroleum Equipment (India) Pvt Ltd as a Senior Electronic Design Engineer, where he was responsible for the development of fuel dispenser electronics for all configurations of dispensers, hardware architect design engineering, software validation and upgradation engineering, design and development of schematic on Altium, firmware development on COOCOX COIDE, validation and integration, power requirement analysis, and power supply design implementation and validation. Sunil holds a Master of Engineering (MEng) degree in Industrial Electronics from the Maharaja Sayajirao University and a Bachelor of Engineering (B.E.) degree in Electronics from BVM Engg College. He has a strong tech stack that includes software engineering, testing, integration, design, Python, and senior software engineering.